PepperType Lab
maD_maX_
Join Date: 2013-04-07 Member: 184678Members
Join Date: 2013-04-07 Member: 184678Members
I did it!! I figured out how to get from .max to editable parametric (lost detail)... Anyway my first creation, a Prototype lab Pepper shaker that is almost 5 inches tall... I plan to have it printed in a green ceramic.
Next, im not sure ill probably to the armory salt shaker to match it. Oh and i have to figure out how to order this stuff with out getting on my wife's bad side.
I also have .stl for it if you want to try and print it yourself...
*I dont know when ill be able to print this
im graduating this May and the wife probably wont let me until then*
**Disclamer I have not printed this yet, I have never printed in Ceramics so if use the following link i cant promise anything**
https://www.shapeways.com/model/1775046/peppertype.html?li=aeTabs
Next, im not sure ill probably to the armory salt shaker to match it. Oh and i have to figure out how to order this stuff with out getting on my wife's bad side.
I also have .stl for it if you want to try and print it yourself...
*I dont know when ill be able to print this
im graduating this May and the wife probably wont let me until then***Disclamer I have not printed this yet, I have never printed in Ceramics so if use the following link i cant promise anything**
https://www.shapeways.com/model/1775046/peppertype.html?li=aeTabs
Comments
https://www.shapeways.com/model/1775394/gorgie.html?li=aeTabs
EDIT: even I cringe at this one.
IP saucer
A welder lighter might even work
Gorge tunnel, plz
We are going to the gutter and still digging. lolz
And I was going to make a joke about veils... but I think that might be in poor taste