Problem With Custom Models,sprites, And Sounds

TheOsiris2

Ok well I have basically replaced every sound(including map sounds) with an Aliens V Predator sound pack, all the guns with an avp pack and all the buildings aliens and rines, as well as all the player models aliens soldier gestate membrane and heavy armor!
So my problem is for some reason every once in a while(more often as marine) it freezes up and I have to ctrl+alt+delete.
I also use basic scripts, 3jump, pistol, turnaround, and wiggle.

System Specs:
1024 dual ram
~45gb Western Digital 10000rpm hard drive
ATI All in wonder 9600 XT
SOLTEK Motherboard
Sony CD Rom Drive(what it sais on front): 52X/32X/52X/16X
JBL 4.1 Speakers(no center)
Samsung SyncMaster 915n flat screen monitor(newest flat screen supposed to be able to go as low as 8ms(w/e that means))

FPS: 69-70(doesnt go any lower or higher) MS: ~80-90
IN: ~50-150 - 2.5 - 3.25 k/s
OUT: ~20-30 - 2.00 - 2.20 k/s
Loss: 0 Choke: 0 (occasionally goes to 1-3 but then drops back down)

Also how can i get my FPS to go higher, originially i was at about 30 FPS but then I turned on vertical sync(yea i know i should turn it off) and also this thing in ATI Catalyst control center called tripple buffering which makes it so my FPS doesnt go lower than my refresh rate(or at least it tries to not let it) which my refresh rate is 72(the most I can push my monitor to do) Also my max fps(in .cfg) is set to 121

So here are the questions now that u have the information:
Why am I crashing so much?
How can i get my Frames Per Second to 100 FPS or higher?

If u need any more information just ask and I will get it for u

Faskalia

you need to set developer 1 in your console.
But the engine is capped at 100 fps, if i am correct. And what you actually see is capped by your monitors refresh rate anyway.

and for improved performance:

Set aa and af both to zero, turn vsync off and use a high resolution instead.

Or you could use a low resolution and set aa and af to high values.

TheOsiris2

ok im kind of confused i turned off vysnc and such and now im getting ~100fps but is like goes down to 30 and back up again but thats fine, but what do i type in console? Also does any of that that u told me help stop crashing?

TheOsiris2

ok now fps is fine but i still crash a lot, but i figured out the problem!
It is the welder, every time somone uses a welder i crash so I need to know what models, sprites, sounds and anything else that have to do with a welder name s are so i can replace them with the regular welder! So if u could tell me all the welder sounds, sprites, and models names and where they go that would figure out my problem!